Make a computer network in Windows Xp

Computer networking is to connect two computers or more, in order to exchange resources such as sharing files, printers, etc. using the same protocol, in this case the TCP / IP. And for pembuatanya necessary device as follows:
• Two or more computers.
• LAN Card / NIC in accordance with the number of computers (for now typically have an onboard computer).
• UTP Cables as needed
• Crimping Tang
• RJ45 connector
• Switch / Hub if you want to use the three computers ata u more
Scissors
DECIDE HOW MANY WANT TO MAKE A COMPUTER NETWORK?
To connect the two computers is not necessary switches and wiring using UTP cable with a straight type, while for networks with three or more computers using switches and UTP cabling configuration of cross-over (on the wiring will be discussed later).

LOADING ON CABLE RJ-45 UTP
Because in this tutorial we will use the UTP cable as a medium, then we need to attach the RJ-45 connectors on the cable so they can be plugged in the LAN CARD, as has been said earlier configuration of the network two computers with three different computers, the way is as follows:

Configurations of two computer using a cross-over
• Peel the outer skin of both ends of UTP cable using a crimping blade or scissors, with a length adjusted.
• Then sort the colors by the rules if one end of the cable using T568A configuration. the end of the cable only use T568B. (Configuration can be seen in the figure below).
• After both ends of the cable colors are sorted according to the above configuration, align the UTP cable ends by cutting a little part of the cable (no cable in the peel).
• Insert the cable into the RJ -45 careful not to confuse the order.
• Then Crimping / cable clamp using crimping pliers until terdengan wearing a clicking sound.

LOADING CABLE UTP is already installed CONNECTORS TO PC
Once installed UTP cable connector, the next step is plugging UTP cable to a computer LAN CARD, if only two computers menggun will then install a UTP cable RJ -45 who have been connected with the configuration of cross-over to each computer, but if it consists of three computers or more then we should use the switch.

Thank you ... Please give advice.